Accessing IOTA & network configuration

To access the IOTA over the network, connect to the HTTPS interface by browsing to the device IP of your IOTA.

The full URL should be: https://<ip_addr>

DHCP mode is enabled by default. If no IP is assigned to the IOTA, the default fallback IP is 169.254.1.1.

To login, use the following initial credentials:

• Default username: admin
• Default password: admin

Note: Make sure to change the default credentials as soon as possible.

Navigate to IOTA Settings > Network Configuration to modify the IOTA network settings. The IP address, network mask, gateway and DNS server can be set manually if Method is set to Static. If Method is set to DHCP Dynamic, IOTA will attempt to receive network settings from a DHCP server.

Local Access
When enabled, connections to the IOTA user interface from the subnetwork IOTA is located on are accepted. When disabled, they are rejected.

Remote Access
When enabled, connections to the IOTA user interface from subnetworks other than the one IOTA is located on are accepted. When disabled, they are rejected.

Activate
Enable or disable 802.1x authentication.

Authentication
Defines the authentication method:

• 'EAP-MD5': The EAP-MD5 (message-digest algorithm v5) method checks against the MD5 hash of the user password for authentication. The EAP-MD5 is defined in RFC 2284.
• 'EAP-TLS': The EAP-TLS (Transport Layer Security) uses Public key Infrastructure (PKI) to set up authentication using a RADIUS or other authentication server. This protocol requires client-side certificates for communicating with the authentication server. The EAP-TLS is defined in RFC 5216.

Identity
Specifies the username for the 802.1x EAP-MD5 or EAP-TLS server.

Password
Specifies the password for the 802.1x EAP-MD5 server.

CA Certificate
The CA certificate file (Certificate Authority) in PEM format for the 802.1x EAP-TLS server (optional).

Client Certificate
The client certificate file in PEM format for the 802.1x EAP-TLS server.

Private Key
The private key certificate file in PEM format for the 802.1x EAP-TLS server.

Private Key Password
Specifies the password for the private key file for the 802.1x EAP-TLS server (optional).

ZeroTier provides an easy way to remotely access the device via a P2P VPN and manage virtual networks on a cloud application. See ZeroTier configuration for more information.

Note: The ZeroTier access is a licensed feature. The Expiration section shows the service expiration date of the current ZeroTier License.